212 Using the Operator Panel Menus and Keypad
• Quantity
Purpose:
To specify the number of copies to print.
Values:
• Image Enhance
Purpose:
To specify whether to enable the Image Enhance feature, which makes the boundary line between black and white
smoother to decrease jagged edges and enhance the visual appearance.
Values:
•Draft Mode
Purpose:
To save toner by printing in the draft mode. The print quality is reduced when you print in the draft mode.
Values:
• Line Termination
Purpose:
To add the line termination commands.
Values:
• Output Color
Purpose:
To specify the color mode to Color or Black & White. This setting is used for a print job that does not specify a
print mode.
Values:
1* Sets the value in increments of 1.
1–999
Off Disables the Image Enhance feature.
On* Enables the Image Enhance feature.
Disable* Does not print in the draft mode.
Enable Prints in the draft mode.
Off* The line termination command is not added.
CR=CR, LF=LF, FF=FF
Add-LF The LF command is added.
CR=CR-LF, LF=LF, FF=FF
Add-CR The CR command is added.
CR=CR, LF=CR-LF, FF=CR-FF
CR-XX The CR and LF commands are added.
CR=CR-LF, LF=CR-LF, FF=CR-FF
Black & White Prints in the black and white mode.
Color* Prints in the color mode.
To Next Page
Loading...
