Using the Operator Panel Menus and Keypad 243
• Resolution
Purpose:
To specify the resolution level to be used for fax transmission.
Values:
NOTE:
• Faxes scanned in the Super Fine mode transmit at the highest resolution supported by the receiving device.
• Original Type
Purpose:
To select the default document type.
Values:
• Lighten / Darken
Purpose:
To set the default copy density level.
Values:
• Delayed Send
Purpose:
To set a specific time for the fax transmission to start. Once the Delayed Send is activated, your printer stores all of
the documents to be faxed into its memory and sends them at the specified time. After faxing in the Delayed Send
mode is complete, the data in the memory is cleared.
Values:
Standard* Suitable for documents with normal sized characters.
Fine Suitable for documents containing small characters or thin lines or documents
printed using a dot-matrix printer.
Super Fine Suitable for documents containing extremely fine detail. The Super Fine mode
is enabled only if the receiving device also supports the super fine resolution. See
the notes below.
Ultra Fine Suitable for documents containing photographic images.
Text* Suitable for documents with text.
Photo Suitable for documents with photos.
Lighten2 Makes the fax lighter than the original. Works well with dark print.
Lighten1
Normal* Works well with standard typed or printed documents.
Darken1 Makes the fax darker than the original. Works well with light print or faint pencil
markings.
Darken2
Hours Specifies the fax transmission start time when sending a fax at a specified time.
Minutes
To Next Page
Loading...
Need help?
General
