Fuji Xerox DocuPrint CM225FW

242 Using the Operator Panel Menus and Keypad
Gray Balance
Purpose:
To specify the default gray balance level within the range of -3 to +3.
Values:
• Sides Per Pages
Purpose:
To print two original pages to fit onto one sheet of paper.
Values:
• Edge Erase
Purpose:
To specify the value of the top and bottom margins.
Values:
• Paper Error
Purpose:
To specify whether to display the paper size error.
Values:
Fax Defaults
Use the Fax Defaults menus to configure a variety of fax features.
NOTE:
• The Fax service cannot be used unless you set up a region code under Region. The touch panel displays an error message
when the region code is not set up.
• The value marked by an asterisk (*) is the factory default setting.
Gray -3 to +3 Sets the color balance level of density gray.
Off* Does not perform multiple-up printing.
Auto Automatically reduces the original pages to fit onto one sheet of paper.
Manual Prints the original pages onto the one sheet of paper in the size specified in
Reduce/Enlarge.
Top/Bottom
(050 mm)
(02.0 inch)
4* mm (0.2* inch) Sets the value in increments of 1 mm (0.1 inch).
Left/Right
(050 mm)
(02.0 inch)
4* mm (0.2* inch) Sets the value in increments of 1 mm (0.1 inch).
Middle
(050 mm)
(02.0 inch)
0* mm (0* inch) Sets the value in increments of 1 mm (0.1 inch).
Off*
On