Printer Connection and Software Installation 53
• WPS-PBC
You can start WPS-PBC from the operator panel.
NOTE:
• WPS-PBC is available only when the wireless LAN access point (Registrar) or router supports WPS-PBC.
• Before starting WPS-PBC, confirm the position of the WPS button (button name may vary) on the wireless LAN access point
(Registrar) or router. For information about the WPS operation on the wireless LAN access point (Registrar) or router, refer to
the manual supplied with the product.
1 Press the (System) button.
2 Select the Tools tab.
3 Select Admin Settings.
4 Select Network.
5 Select Wireless.
6 Select WPS Setup.
7 Select Push Button Configuration.
8 Select Start Configuration.
9 Confirm that Setting WPS is displayed, and press the button on the wireless LAN access point, within two
minutes of the step 8 operation.
NOTE:
• For details about WPS operation on the wireless LAN access point, refer to the manual supplied with the wireless LAN
access point.
When WPS is successful, wireless connection is established and setup for wireless LAN is complete.
• WPS-PIN
The PIN code of WPS-PIN can only be configured from the operator panel.
NOTE:
• WPS-PIN is available only when the wireless LAN access point (Registrar) or router supports WPS-PIN.
• For the WPS operation on the wireless LAN access point (Registrar) or router, refer to the manual supplied with the product.
1 Press the (System) button.
2 Select the Tools tab.
3 Select Admin Settings.
4 Select Network.
5 Select Wireless.
6 Select WPS Setup.
7 Select PIN Code.
8 Write down the displayed 8-digit PIN code or select Print PIN Code. The PIN code is printed.
9 Select Start Configuration.
To Next Page
Loading...
Need help?
General
