58 Printer Connection and Software Installation
16 Enter the value of the subnet mask using the number pad.
17 Select .
The cursor moves to the next digit.
18 Repeat steps 16 to 17 to set the subnet mask, and then select OK.
19 Confirm that Settings Become Effective After Restart. appears, and then select Close.
20 Select Gateway Address.
The cursor is located at the first digit of the gateway address.
21 Enter the value of the gateway address using the number pad.
22 Select .
The cursor moves to the next digit.
23 Repeat steps 21 to 22 to set the gateway address, and then select OK.
24 Make sure that the message Settings Become Effective After Restart. appears, and then select
Close.
25 Turn off and turn on the printer.
See also:
• "Operator Panel" on page 27
Using the Printer Setting Utility (Windows Only)
The following procedure uses Windows 7 as an example.
1 Click Start ï‚® All Programs ï‚® Fuji Xerox ï‚® Fuji Xerox Printer Software for Asia-Pacific ï‚® your printer ï‚®
Printer Setting Utility.
NOTE:
• The window to select a printer appears in this step when multiple print drivers are installed on your computer. In this
case, click the name of the desired printer listed in Printer Name.
The Printer Setting Utility appears.
2 Click the Printer Maintenance tab.
3 Select TCP/IP Settings from the list at the left side of the page.
The TCP/IP Settings page is displayed.
4 Select Panel from IP Address Mode, and then enter the values in IP Address, Subnet Mask, and Gateway
Address.
5 Click Restart printer to apply new settings to take effect.