Troubleshooting and tips
82 A26391-K124-Z100-1-7619
Previous boot incomplete - Default configuration used
Due to an error during the previous system boot, default values were used for certain settings.
Check the BIOS Setup and the settings.
Ê Press the [F1]
[F1][F1]
[F1] function key when prompted to do so.
Real Time clock error
Ê Contact your sales outlet or our Hotline/Help Desk.
nnnnK Shadow RAM failed at offset: xxxx Failing Bits: zzzz
Ê Contact your sales outlet or our Hotline/Help Desk.
System battery is dead - Replace and run SETUP
Ê Contact your sales outlet or our Hotline/Help Desk.
System cache error - Cache disabled
Ê Contact your sales outlet or our Hotline/Help Desk.
nnnnK System RAM failed at offset: xxxx Failing Bits: zzzz
Ê If you have installed a DIMM, you should remove the module and reboot the workstation.
If the error message is no longer displayed, the error concerned is DIMM-related. Should you
receive this error message again, please contact your dealer.
System timer error
Ê Contact your sales outlet or our Hotline/Help Desk.
Contact with Hotline/Help Desk
If you are unable to solve a certain problem, please contact the Hotline/Help Desk. Additional details
are contained in the "Help Desk" supplement. Please have the following information ready when you
call:
• The model name and serial number of the workstation. The serial number is located on a
sticker on the underside of the workstation.
• Notes of any messages that appear on the screen and information on acoustic signals.
• Any changes you have made to the hardware and/or software or the BIOS settings after
receiving the workstation.
• Your system configuration and all peripheral devices connected to your system.
• Your sales contract.
To Next Page
Loading...
Need help?
General