USING SETUP MODE
5-42 User's Manual
Table 5.6 ADJUST Items and Options (Cont.)
NOTE:
• Underlined options are the factory defaults.
• When you select less than 1/6IN, please make sure that Print data
from software has enough top margins so that no print data will not
be printed out of paper.
ADJUST
Items
Options Description
<FCUTORG> -1/6 IN
0/6 IN
1/6 IN
1.8/6 IN
:
6/6 IN
:
66/6 IN
Sets the top-of-form for front single
sheets. The top-of-form is defined
distance from top of paper to bottom of
print line. The default is recommended
if your top margin is not software-
specified.
<FCUTFIN>
0/180, ..., 29/180
Fine-tunes the top-of-form position for
front single sheets.
Increases top-of-form in increments of
1/180 inch
(0.14 mm).
<RCUTORG> -1/6 IN
0/6 IN
1/6 IN
1.8/6 IN
:
6/6 IN
:
66/6 IN
Sets the top-of-form for rear single
sheets. The top-of-form is defined
distance from top of paper to bottom of
print line. The default is recommended
if your top margin is not software-
specified
<RCUTFIN>
0/180, ..., 29/180
Fine-tunes the top-of-form position for
rear single sheets.
Increases top-of-form in increments of
1/180 inch
(0.14 mm).
To Next Page
Loading...
