TROUBLE-SHOOTING
User's Manual 7-5
Table 7.1 Print Quality Problems and Solutions (Cont.)
Problem Solution
The next print line
starts where the
previous line ended
instead of at the left
margin.
Change the LF-CODE setting in the printer
setup mode to LF & CR. See the section
MENU1 and MENU2 Items and Options in
Chapter 5.
The top of form of
continuous form
displaces gradually.
Variation of the top of form is saturated in a few
pages and displacement is about 1mm or less. In
this case adjust value is prepared in setup mode.
See ADJUST Items and Options and search
<FCNTADJ> or <RCNTADJ>.
Variation of the top of form isn’t saturated. In
this case setting of page length isn’t correct.
Make sure that page length setting equal actual
page length exactly.
In general page length of continuous form is
multiple of 0.5inch. Anyway don’t set page
length of continuous forms using mm unit.
To Next Page
Loading...
