Fujitsu ETERNUS AF250 S2 - Page 90

User setup
(1) In [Action], click [Setup SNMP User].
The [Setup SNMP Agent User] screen appears.
(2) In the user list of the [Setup SNMP Agent User] screen, click the [Add] button.
(3) Enter the user name, set the required items, and click the [OK] button.
The screen display returns to the user list of the [Setup SNMP Agent User] screen.
(4) Check the user that was set in Step (3) is added in the user list and click the [Set] button.
A confirmation screen appears.
(5) Click the [OK] button.
The SNMP user settings are applied.
(6) Check the setting completion message and click the [Done] button.
The screen display returns to the [Network] screen.
5 Trap setup
Set up the destination for sending the SNMP Trap.
This step is not required when ETERNUS SF Storage Cruiser is used to monitor the ETERNUS AF.
(1) In [Action], click [Setup SNMP Trap].
The [Setup SNMP Agent Trap] screen appears.
(2) In the trap list of the [Setup SNMP Agent Trap] screen, click the [Add] button.
Chapter 6 Monitoring Settings
6.2 Various Notification Settings
90
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays
Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1832-04ENZ0