IMPORTANT
When connecting the mini SAS HD cable between enclosures, check the direction of the connector (the tab
must be pointed downward) and firmly insert all the way in.
To disconnect the mini SAS HD cables between enclosures, hold the tab and then pull out the connector.
The following figure shows how the mini SAS HD cables between enclosures are connected when drive enclosure
2 is added.
Connection configuration between
Contr
oller 0 and the I/O module line 0
Connection configuration between
Controller 1 and the I/O module line 1
Controller enclosure
Drive enclosure 1
Drive enclosure 2
(drive enclosure
that is to be added)
Controller 0 Controller 1
Remove
fr
om here
Connect here
Connect here
Remove
from here
Connect here
Connect here
Connect here
Connect here
1 In the [Storage] screen of [Component] on the ETERNUS Web GUI screen, check that all components of
the ETERNUS DX are in normal status. In addition, check the DE-IDs (drive enclosure numbers) of the
installed enclosures in the [Drive Enclosure] screen.
4. Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
45 Operation Guide (Basic)
To Next Page
Loading...
