Creating Scanned Images Depending on Intended Use (for Mac OS Users)
381
Creating Scanned Images Depending on
Intended Use
This section explains about various ways of using the ScanSnap.
Scanning Only One Side of a Document
By default, the ScanSnap scans in duplex mode.
To perform simplex scanning, perform the following steps to change the setting.
1. Select [Settings] from the ScanSnap Manager menu.
For details about the ScanSnap Manager menu, refer to "ScanSnap Manager Menu
(Mac OS)" (page 39).
D The ScanSnap setup window appears.
2. In the [Scanning side] pop-up menu in the [Scanning] tab, select
[Simplex Scan (Single-sided)].
3. Click the [Apply] button in the ScanSnap setup window.
4. Click the [ ] button in the upper left corner to close the ScanSnap
setup window.
To Next Page
Loading...
