Connecting the ScanSnap to a Wireless LAN
56
Reconnect to a Wireless Access Point Using the
ScanSnap WPS Button
If the Wi-Fi indicator lights up or flashes in orange, reconnect the ScanSnap to a WPS
compatible wireless access point. The reconnection can be established easily by pressing
the WPS button on the ScanSnap.
Perform the following procedures to connect.
1. Turn on the ScanSnap.
For details, refer to "Turning the ScanSnap ON" (page 45).
2. Turn on the Wi-Fi switch on the back of the ScanSnap.
D After blinking blue, the Wi-Fi indicator lights up in blue or orange.
ATTENTION
Perform the following before you connect using the WPS button.
z If the ScanSnap Wireless Setup Tool is running while the ScanSnap is being connected to the
computer with a USB cable, exit the ScanSnap Wireless Setup Tool.
z If scanning is currently being performed from ScanSnap Manager or a mobile device, end the
scanning operation.
HINT
Button names and operating procedures may differ depending on the wireless access point. For details,
refer to the manual for your wireless access point.
Wi-Fi
OFF ON
To Next Page
Loading...
