Cleaning the Inside of the ScanSnap
442
How to perform cleaning
1. Clean the following locations:
z Brake roller
z Idler roller
z Glass
z Pick roller
z Ultrasonic sensor
1. Unplug the cables from the ScanSnap.
2. Pull the ADF release tab to open the ADF top section.
3. Clean the following locations with a cloth moistened with Cleaner F1.
ATTENTION
z Do not use water or mild detergent to clean the inside of the ScanSnap.
z It may take a long time for Cleaner F1 to dry if an excessive amount is used. Moisten the cloth
with a moderate quantity.
Wipe off the cleaner completely to leave no residue on the cleaned parts.
z Be careful when cleaning not to catch the cloth in the document detection sensor.
ADF release tab
ADF top section
ADF paper chute
(cover)
Document detection
sensor
To Next Page
Loading...
