Fujitsu ScanSnap S300 - 2.1 Installing the Supplied Programs

6
2.1 Installing the Supplied Programs
"Installation" of programs is the act of copying the program files supplied with the ScanSnap into
the hard disk of your personal computer so that the environment for using the ScanSnap is created
on the personal computer in which you install the program files.
■ Before Installing the Supplied Programs for the ScanSnap
Before installing the supplied programs for the ScanSnap, perform the following preparations:
1. Check your system.
The system requirements for the ScanSnap are as follows:
■ Operating system
One of the following operating systems is required:
• Windows 2000
• Windows XP
• Windows Vista
*:
Service Pack 1 or later must be applied
■ Personal computer
• For Windows 2000 and Windows XP:
Recommended: Intel
®
Celeron
®
M 430 1.73 GHz or higher
Minimum: Intel
®
Pentium
®
III 600 MHz or higher
• For Windows Vista:
Recommended: Intel
®
Celeron
®
M 430 1.73 GHz or higher
Minimum: Intel
®
Pentium
®
4 1.8 GHz or higher
• CD-ROM drive (used for installation)
• USB port (USB 2.0/1.1)
■ RAM
For Windows 2000 and Windows XP:
Recommended: 512 MB or more
Minimum: 256 MB or more
For Windows Vista:
Recommended: 1 GB or more
Minimum: 512 MB or more
Windows 2000 Windows XP Windows Vista
ScanSnap Manager 3
3
*
3
ScanSnap Organizer 3
3
* 3
CardMinder 3
3
*
3