3.1 Flow of Operations
ScanSnap S300 Operator's Guide 37
Using the ScanSnap
3
■ Finishing Scanner Operation
Exiting ScanSnap Manager
Operation
When you do not want ScanSnap Manager to stay resident on your computer, right-click the
ScanSnap Manager icon
on the taskbar, and select [Exit] in the Right-Click menu to exit
ScanSnap Manager.
Disconnecting the ScanSnap
Operation
1. Close the paper chute to turn off the ScanSnap.
⇒ The ScanSnap Manager icon on the taskbar changes to the inactive state .
The ScanSnap power indicator goes off.
2. Disconnect the USB cable from your computer.
3. Disconnect the Power cable or USB bus power cable from the power outlet or
computer.
HINT
If you exit ScanSnap Manager, you can no longer use the ScanSnap.
To activate ScanSnap Manager again, from the [Start] menu, select [All
Programs]
D [ScanSnap Manager] D [ScanSnap Manager].
HINT
The ScanSnap is turned on/off in conjunction with the personal computer or
opening/closing of the paper chute. Ordinarily, you can forget about turning on/
off the ScanSnap being connected to the personal computer.
S
S
S
S
To Next Page
Loading...
