Appendix
Methods for accessing the utilities
Recovery and Utility Tools are preinstalled in a hidden partition by the factory, or
they can be accessed by using the bootable d isc.
Note: The Recovery and Utility tools may be deleted from your hard disk drive if you modify the
partitions. If that occurs, you will not be able to use the hidden partition for booting to Recovery
and U tility Tools, but you will still be able to boot from the Bootable Disc.
Determining wh ether Recovery and Utility is pre-loaded
1. Turn o n or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to the Application Menu.
3. Check w hether the Recovery and Utility option is prese nt. If it is not present, it means that
the utility must be used from the Bootable Disc. Proceed to the "“Running Recovery and
Utility from the Bootable Disc”"section if Recovery and Util ity is unavailable.
Running Re covery and Utility from hard disk
1. Turn o n or reboot your system. When the Fujitsu logo appears, press the
F12
key.
2. Use the
Tab
key to get to the Application Menu.
3. Move the c ursor down to Recovery and Utility a nd press the
Enter
key.
4. Choose your language, if necessary. Select Recovery and Utility to pro ceed .
5. Three tool options appear: Diagnostics, Recovery, and Utility (refer to the" Recovery and
Utility tools "section below for instructions on how to use these tools).
6. If this w as successful please skip the next step and go to the "Recovery and Utility too ls" section.
7. If this was NO T successful, please go to the ne xt step.
Running R ecovery and Utility from the Bootable Disc
Note: If your system does not have an internal writable DVD drive, connect
your system to an external drive.
To verify/change the boot-up priority (rather than booting-up from the hard drive or
an external media drive), perform the following steps:
1. Power o n your system. When the Fujitsu logo appears on the screen, press the
F12
key.
2. Insert the bootable disc into the drive tray.
3. Highlight the CD/DVD option from the Boot menu, then press
Enter
.
4. Click OK.
5. Select CD/DVD boot m ode: UEFI Mode, if applicable then press
Enter
.Whilethe
files are being loaded from the disc, the Fujitsu logo screen will appear followed
by a progress bar at the bottom of the screen.
Recovery a nd Utility t ools
Note: R ecovery and Utility to ols m ay not be available on your system depend ing
on the regio n from which the system w as shipped.
Diagnostics tool: The Diagnostics tool is designed for use by IT professionals. It is not likely you
will need to use this tool. If you should need to use this tool, perform the following steps:
1. Press the Diagnostics Toolbutton to start the Diagnostics tool.
2. Read th e note, and then click OK.
120 Fujitsu
To Next Page
Loading...
Need help?
General
Weight and Dimensions
