Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
10
The power supply is capable of outputting DC 20,000V at up to 20mA. This power is also provided to
the discharge terminals on the laser tube itself. Your laser shipped with silicone terminal covers that
prevent access to bare wiring—notify Full Spectrum Laser support and immediately cease operations
if these covers ever slip and expose bare wire.
DO NOT open any of the machine’s access panels while the unit is plugged in. Opening a panel
may expose the operator to the unit’s AC input power. The AC input power is potentially lethal and is
located on the far right within the cabinet.
NEVER make or break any electrical connections to the system while the unit is turned on.
NEVER access the electronics area with hands or tools unless the unit is disconnected from power
for at least one hour.
NEVER replace the installed 10 amp fuse with a fuse of a higher rating. This will void your warranty
and the electronics will not be adequately protected from surges or short circuits.
POWER ON/OFF is controlled by the switch at the back of the machine. To power the machine on,
press the (-) side down. To turn power off, press the “o” side down.
IN CASE OF A BLOWN FUSE always contact Technical Support before replacing any fuses.
Electrical Safety
To Next Page
Loading...
