Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
90
With a little care and maintenance, your Muse Laser Cutter will remain clean and continue to run at
top efciency for years to come. Be aware of all safety and maintenance issues with your machine
by following all the safety instructions in this manual.
Replacing the Laser Tube
This section provides procedures and a walkthrough to replace the laser tube on your Muse. Although
it should last for hundreds of projects, the laser tube is considered a consumable and will eventually
need to be replaced. Please carefully read all instructions before beginning the replacement
procedure as there are several critical steps which must be properly followed to avoid breaking the
laser tube. The included pictures show how to properly connect wires to the tube’s electrodes and
secure the connections.
REQUIRED PARTS AND TOOLS:
• 45W REPLACEMENT TUBE
• 2.5 MM HEX WRENCH
FRAGILE GLASS!
Pulling on the tube wires will break
your laser tube at the neck. The water connections are very
fragile, DO NOT pull or force the connection tubes— gently
work the tubes off of the connectors.
SHOCK WARNING! The capacitors in the power supply
retain power even after turning the laser off. To ensure your
safety, turn off the laser, remove the power cord and wait at
least 1 hour before accessing the power supply.
SECTION VIII. HARDWARE & MAINTENANCE
To Next Page
Loading...
