Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
5
General Safety
Read and be familiar with all safety protocols and procedures before operating any machinery. It is the
responsibility of the operator to ensure all safety precautions are correctly followed and the machine is
properly assembled and in working order.
ALWAYS inspect the laser cutter for damage or breakage before each use. Do not
operate machinery that is damaged or defective in any way.
ALWAYS have a clean, level, and open work space to unbox and place your laser cutter
ALWAYS be aware that the laser tube is made of glass and is therefore extremely
fragile and can cause severe lacerations if broken.
ALWAYS be aware that the laser tube is lled with CO2 gas. While carbon dioxide is a
class 2.2 gas (nonammable and nontoxic), release of this gas from the laser tube will
render your laser inoperable.
NEVER modify, disassemble, or in any way alter the construction of the laser and never
start up a system that has been modied or disassembled.
NEVER leave the laser system unattended during operation.
KEEP YOUR LASER SYSTEM CLEAN – A build up of cutting and engraving
residue and debris is dangerous and can create a re hazard. Keep your laser system
clean and free of debris. Regularly remove the cutting grid to clean any small pieces
that have gotten stuck or fallen through.
DO NOT disassemble the machine or remove any of its protective covers.
NEVER place hands or ngers into moving parts such as cooling fans.
To Next Page
Loading...
