Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
96
Appendix A: Coolbox
Unboxing
Carefully remove the items from the box as directed.
1. Remove the Top Foam: Beneath the top foam, you will see the coolbox and all needed
accessories.
2. Remove Right Packaging Box: Remove the larger box to the right and check that all the following
parts are included: 2-Pin Cable (1), 4-Pin Cable (1) and AC Power Cable (1).
3. Remove Right Packaging Box: Remove the smaller box to the left and check that all the following
parts are included: Cooling Fan (1), 4-Pin Molex to 4-Pin Terminal Connector (1) & and a small plastic
bag containing: 2mm Hex Key (1), 2.5mm Hex Key (1), 5.5/7mm Wrench (1), two M3 Nuts (2) and
four Acorn Nuts (4).
4. Remove Coolbox:Start by removing the three pieces of side foam, securing the coolbox. Then,
gently lift the coolbox from the box. You can lift and remove the adapter plate and the foam sheet at
the same time as the coolbox.
5. Remove Exhaust Fan Cowling:Remove the exhaust fan cowling and its support foam.
6. Remove Muse Side Panel: Remove foam covering the side panel. Remove the new Muse side
panel from the box. Your coolbox is unboxed.
Coolbox Unit (1)
Exhaust Fan Cowling (1)
Adapter Plate (1)
2-Pin Cable (1)
4-Pin Cable (1)
AC Power Cable (1)
Cooling Fan (1)
Connector (1)
2.5mm Hex Key (1)
5.5/7mm Wrench (1)
M3 Nuts (2)
M4 Acorn Nuts (4)
Parts Checklist
Assembly
1. Safety First: Before starting this procedure, turn off your muse and unplug it from all power
sources. We recommend to wait at least 20 minutes to ensure no residual electricity remains.
2. Remove Existing Exhaust Plate: Using the provided 2.5mm hex key, remove the four (4) screws
from the existing exhaust plate and set them aside in a secure location. Then remove the existing
exhaust plate. You will no longer need the old exhaust plate, however, hold on to two (2) of the screws
to secure the new adapter plate, in the next step.
3. Attach Adapter Plate: Using the 2.5mm hex key and the two (2) screws saved from removing the
exhaust plate (see step 2), attach the adapter plate on the back of your Muse, where the old exhaust
plate was.
4. Attach Exhaust Fan: Using the 5.5/7mm wrench, attach the exhaust fan to the adaptor plate with
the two (2) M3 Nuts. Note that the arrow on the fan needs to be pointing out the case.
5. Connect Exhaust Fan to Cowling: Carefully connect exhaust fan connector to exhaust fan
cowling connector. Do not force the connection. The connectors only t one way and should gently
slide together and secure.
6. Attach Fan Cowling to Adapter Plate: Carefully slide the fan cowling onto the adapter plate by
aligning it straight and then pushing forward. Hold the cowling steady and secure with the four (4)
acorn nuts. Tighten until secure using your ngers or the provided 5.5/7mm wrench.
IMPORTANT: Once cowling is attached, make sure the wires are not interfering with the fan. Inspect
visually and then spin the fan by hand from the inside of the Muse to ensure it is unobstructed.
To Next Page
Loading...
