Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
17
3. Ventilate Outside: Set the open end outside of a window or an installed ventilation outlet.
Check your system for leaks—most can be remedied with duct tape. Please be aware that the
protective housing is not designed to be airtight; the front grill is designed to allow an exhaust
system to draw fresh air through the work area.
4. Connect to Power: Plug the exhaust fan power cord into the lower power plug marked
“exhaust fan” on the back of your Muse. Note that accessories plugged into the back of your Muse will
only turn on when the laser is red (as intended to save power).
5. Fume Extractor Upgrade (optional): You can also upgrade to a fume extractor. Fume
extractors are air purifers that clean the air through HEPA Filters. Fume extractors do not require
outside ventilation. This is a great option for workshops that do not have the option to ventilate
outside. Both the extractors and the ters are available on the Full Spectrum Laser website at
https://www.fslaser.com/Products/LaserAccessories. Ask a customer support representative which
fume extractor is right for your needs.
https://www.fslaser.com/Products/LaserAccessories.
Large Fume Extractor
Medium Fume Extractor
Small Fume Extractor
Fume Extractor lters require routine cleaning and replacement, dependent on use and materials cut.
Generally, fume extractor suction will diminish and odors will be detected as lters clog.
NEVER use a fume extractor without all lters in place.
Follow these maintenance guidelines:
Pre-Filters
Clean often. Use a shop vacuum to clean as debris builds. Check weekly, especially if cutting a lot of
wood. When accumulated debris remains over 70% after cleaning, replace Pre-Filter.
HEPA Filters
Clean immediately when suction is reduced. Use a shop vacuum to clean accumulated dust. When
cleaning does not return optimal suction power, replace HEPA Filter.
Activated Carbon Filters
Clean when odors are detected or suction is reduced. Gently shake excess dust and debris from
carbon lter and follow with a shop vacuum. When cleaning no longer eliminates detectable odors,
replace Activated Carbon Filters.
To Next Page
Loading...
