Full Spectrum Laser Muse - Page 52

Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
51
zooming or panning.
Fit Selection: Fit the current selection to the viewable page area.
Fit Layer: Fit the currently selected layer to the viewable page area.
Fit All (Alt+Ctrl+0): Fit all layers, whether or not selected, to the viewable page area.
Magnication
+6% - +25600% Magnication: Increase or decrease magnication.
Zoom In (Ctrl++): Enlarges workspace screen detail and size.
Zoom Out (Ctrl+-): Reduces workspace screen detail and size.
View Mode
Full View: Set to full view mode.
Fast View: Set to fast view mode.
Outline View: Set to outline view mode.
Output View: Set to output view mode.
Show Rulers (Ctrl+Alt+R): Toggle rulers on and off.
Show GuideLines (Ctrl+,): Toggle guidelines on and off.
Show Grid (Ctrl+Alt+G): Toggle grid on and off.
Show Tooltips (Ctrl+]): Toggle tooltips on and off.
Show Effects (Ctrl+E): Toggle effects on and off.
Snap To:
Use Snapping (Shift+F10): Enable or disable the snapping feature.
Use Snap Zones: Enable or disable the snap zone feature.
Snap to Grid: Enable or disable the Snap to Grid feature.
Snap to GuideLines: Enable or disable the Snap to GuideLines feature.
Snap to Full Pixels: Enable or disable the Snap to Full Pixels feature.
Snap to Anchor Points: Enable or disable the Snap to Anchor Points feature.
Snap to Shapes: Enable or disable the Snap to Shapes feature.
Snap to Pages: Enable or disable the Snap to Pages feature.
Show Inspector Panel: Toggle inspector panel on and off.
Show Outline Panel: Toggle outline panel on and off.
Toggle Fullscreen (F): Toggle full screen view on and off.
Muse
Capture Workspace: Initiates camera functions.
Clear Last Visual: Remove last camera image.
Trace Background: Used with camera functions to apply vectors to selected area of image.
Estimate Job Time: Give approximate time for job to complete.
Run Perimeter: Laser continuously outlines the border of the current project. Press again to stop
running perimeter.
Run Job: Run your project. When running, “Play” button is replaced with “Pause” and “Cancel”.
Pause Job: Pause the laser from continuing with current project.
Cancel Job: Stop the laser and cancel current operation.