Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
67
move the laser dot to the top left corner of your material. When placing an engraving
image, leave at least ½” inch of space on the left and right side. When creating engrav-
ings, you must compensate for the left and right overshooting of the laser head. Once
the material looks aligned, click the “Jog Perimeter” button. The laser head will automat-
ically outline the material with the red beam diode. You can then adjust the material as
needed. Note the laser head will continue to outline the material until stopped manually
by clicking the “Run Perimeter” button a second time. See Positioning below for more
options.
7. Adjust Object Properties
It is again important to know if you intend to raster, vector cut or both. Once the le is
imported, and the image is clicked with your mouse, you will have access to the Prop-
erties Tab. Click this tab and select the parameters for your cuts and/or engravings. For
details on setting these parameters, see below.
8. Run Job
Clicking the “Start Job/Play” button begins the laser cutting process. Before doing so,
double check your safety protocol and that your system accessories are connected
properly. Be sure to monitor the job while the laser is ring. If there is a problem, stop
the laser using one of the methods mentioned below.
To Next Page
Loading...
