Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
79
Round: Create rounded corners.
Round2: Create inverted rounded corners.
Bevel: Create beveled corners.
Inset: Create inset corners.
Fancy: Create fancy corners
Autoscale Corners: Toggle autoscale corners on and off.
Uniform Corners: Click to ensure all corners have the same parameters.
Plain Edges:Toggle plain edges on and off.
Corners: Input outside and inside corner curvature.
Radius: Input outside and inside corner radius.
Angles: Input outside and inside corner angles.
To Next Page
Loading...
