Furuno FEA-2107 - Page 276

14. Route Monitoring
14-6
The Alarms page may
show the following
message:
“* = Current selection
differ” indicates which
conditions are currently
set differently as
planned.
Remedy:
Open Chart Alarm
parameters to set them
as they were at the time
the route was planned.
The Selection page may
show the following
messages:
“Current selection is
different” This means
the name of user chart
and/or pilot data in the
monitoring mode is not
the same as route
planning check.
Remedy: Click the Use
button to choose user
chart and/or pilot data in
the monitoring mode.
“This has been
changed after Route
Planning Check” This
means that user chart
and/or pilot data was
modified after the latest
route planning check.
Remedy: Check route
planning for the route
with attached user chart
and/or pilot data.