Furuno FEA-2107 - Page 346

19. Navigation Sensors
19-10
SOG/COG used by the system is shown at the upper right corner of the ECDIS display. In the example below, COG
and SOG are from chosen position sensors and this is indicated with the text “(pos)”. Other text which denote
SOG/COG source are
“(bot)”: Bottom tracking dual-axis log
“(calc)”: Speed calculated from SOG
“(wat)”: Water tracking log
“(arpa)”: Mixed sources of COG and SOG in the connected ARPA radar
“(pos)”: Average of chosen position sensors
“(filter)”: Kalman filter
“(man)”: Manual entry
Note that (pos), (bot), (wat) and (man) could come from direct interfaces of the system or from the connected ARPA
radar.
DUAL LOG
(Bottom track of
dual-axis doppler
log)
RADAR
(measures
SOG/COG
from target
= Autodrift)
Average of
SOG/COG from all
selected Decca,
Loran or
Ref.Target
KALMAN filter
calculation result
from the movement
of position
SOG/COG
used by
the system
Selected and value existts
SOG/COG from all
Average of
selected DGPS,
GPS or SYLEDIS
Selected and value exists
Selected and value exists
Selected and value exists
Not selected
or no value
Water speed
and
Gyro heading
Selected and
value exists
Not selected
or no value
Not selected
or no value
Not selected
or no value
Not selected
or no value
59
°
50.502'N
024
°
52.836'E
WGS 84
FILTER HIGH
HDG 197.9°
SPD
(CALC)
1.8 Kt
SB
(POSN)
1.7 Kt
COG
(POSN)
045.1°
SOG
(POSN)
2.0 Kt
The figure below show the source of docking speed components used for the predictor.
Bow and
stern speed
used by
the system
SOG/COG used by the system
Heading used by the system
Speed (water speed) used by the system
Calculator
ROT used by the system
Installation parameter offset values