7.3 Cautions and information message
7-16
Command answer sentence
“301 Ignored: You are connected with DTE 2 port.”
“302 Ignored: Format Error.”
“303 Ignored: Undefined Command.”
“310 Ignored: Can not abort current process.”
“311 Ignored: Can not Forced Clear current process.”
“312 Ignored: Awaiting message transfer, Can not start PV TEST.”
“313 Ignored: PV TEST has been already started, and now pending.”
“314 Ignored: Sending Message not exist.”
“315 Ignored: Distress Request command not received.”
“316 Ignored: Can not start Distress Alert Test now.”
“320 Ignored: MES is not idle.”
“321 Ignored: Now receiving EGC message.”
“322 Ignored: MES is not Login. Please operate Login.”
“323 Ignored: Current Network is restoration mode.”
“324 Ignored: NCS Common Channel Failure.”
“340 Send message already exist in DCE.”
“341 Message not exist.”
“342 Service request not received.”
“350 Input Error: Service Code”
“351 Input Error: Message Reference No.”
“352 Input Error: Destination Type”
“353 Input Error: LES ID”
“354 Input Error: NCS ID”
“355 Input Error: Channel No.”
“356 Input Error: Date or Time”
“357 Input Error: MES Mode”
“358 Input Error: Navigation Select”
“359 Input Error: Sub_address”
“360 Input Error: Port Select”
“361 Input Error: Geographical Coordinate”
“362 Input Error: Navarea Code”
“363 Input Error: Fixed Area Code”
“364 Input Error: WMO Area Code”
“365 Input Error: NAVTEX Code”
“366 Input Error: EGC Auto Sellection”
“367 Input Error: Protocol Code”
“368 Input Error: Nature Code”
“369 Input Error: Course Data”
“370 Input Error: Speed Data”
“No response from communication unit.”:
Message output from TERM CPU when no response is sent from RF CON/CPU after
sending the command from TERM CPU.
To Next Page
Loading...
Need help?
General
