Furuno FELCOM 15 - Chapter 4. Set up; 4.1 System menu (F8)

4-1
**The brightness adjustment of the display
Press [F6] while holding [Alt] to decrease the brightness of the display at 8 levels.
To increase the brightness, press [F7] while holding [Alt].
4.1 System menu (F8)
4.1.1 Setting by DTE port
The terminal unit: PC which is connected to the DTE port of the Terminal unit: IC-215
shows the same display as the one of the IC-215. Normally, The main system setting is
made by the IC-215. Table 4.1.1 lists the setting by the PC connected to DTE port.
Table 4.1.1 Setting by the DTE port
Setting Note
[F8]-2. System Setup IMN only
[F8]-3. Editor Setup All
[F8]-4. Terminal Setup All
[F8]-6. Auto Mode Setup All
[F8]-7. Email Setup All
[F8]-8. Directories All
1. Station List
2. LES List
5. E-mail Service List
[F8]-9. Configuration
6. Save/Load
Following files are saved and
loaded. See page 5-24.
- Station.dat
- LES.dat
- Emaile.dat
- DTE.dat (
Except
Network
setup in [F8]-2 menu.)
[F10]:Alarm stop For DTE port or IC-215
Chapter 4. Set up