AP4.9 Function settings
AP4-17
5. Select “Server”, followed by [Enter].
Note) Meaning of “PC Mailer”;
Received messages are sent to the PC in the LAN.
6. Select “Server IP”, followed by [Enter].
7. Enter IP address of the mail server, followed by [Enter].
8. Select “Address Mode”, followed by Enter].
9. Select “FIXED”.
Note) Meaning of “Auto”;
The received message is forwarded to the address which appears just
after the keyword in the message. When the keyword is not found, the
message is sent to the address set in “Mail Address”.
10. Select “Mail Address”, followed by [Enter].
11. Enter the mail address received at the mail server, followed by [Enter].
12. Press [Esc] to show [Update].
13. Select “Yes”, followed by [Enter]. The message “Press ESC key to Restart
FELCOM15.” appears.
14. Press [Esc]. The system restarts automatically and new settings are loaded.
When “Delivery To” setting is changed only to “Server” from “Pc mailer”, the
system restart automatically and settings are loaded.
To Next Page
Loading...
