Furuno FELCOM 15 - Page 183

AP4.9 Function settings
AP4-19
Procedure
1. Press [F8][2] to open “System Setup” menu.
2. Select [Network Setup], followed by [Enter].
3. Select “Mail Gateway”, followed by [Enter].
4. Select “Delivery To”, followed by [Enter].
5. Select “Server”, followed by [Enter].
6. Select “Server IP”, followed by [Enter].
7. Enter the mail “server IP address”, followed by [Enter].
8. Select “Address Mode”, followed by [Enter].
9. Select “Auto”.
Note) Meaning of “Fixed”;
The received message is sent to the address designated by “Mail
Address”.
10. Select “Mail Address”, followed by [Enter].
11. Enter the “Mail address”, followed by [Enter].
When the keyword is not found, the message is sent to the address set in “Mail
Address”.
12. Select “Auto Delivery Keyword”, followed by [Enter].
13. Enter the keyword, followed by [Enter]. The keyword is up to 15 characters.
Note)Use characters which appear rarely in the text field. Make sure that all
senders know how to write the keyword and the mail address.
14. Press [Esc] to show [Update].
15. Select “Yes”, followed by [Enter]. The message “Press ESC key to Restart
FELCOM15.” appears.
16. Press [Esc]. The system restarts automatically and new settings are loaded.
When “Deliver To” is changed from “PC mailer” to “Server”, the system restarts
and settings are loaded.