FUTABA T18SZ - Page 115

115
＜ Linkagemenu ＞
3. Select the operating mode for each channel.
"NORM": The model is controlled by signals
from the student transmitter.
"MIX" mode: The model is controlled by
signals from the teacher and student
transmitters. (Reset the student's model data
to the default condition.)
"FUNC" mode (function mode):
The model is controlled by signals from
the student transmitter with the teacher
AFR setting. (Reset the student's model data
to the default condition.)
"OFF": Only the teacher side operates.
7KHVHWWLQJDERYHDOORZVVHWWLQJRIWKHVHUYRWKURZUHODWLYH
WRWKHDPRXQWRIVWXGHQWVLGHRSHUDWLRQZKHQ>0,;@RU
>)81&@ZDVVHOHFWHG
When changing the rate, use the "ʈʈ" "ʈ"
"ʆ" "ʆʆ" button to Tap the [Rate] item of
the channel.
Setting range: -100~+100
Initial value: +100
:KHQWKHYDOXHLVWDSSHGWKHUDWHLVUHVHWWRWKHLQLWLDOYDOXH
4. Set the switch of each channel.
:KHQVHWWLQJWKHVZLWFKDWHDFKFKDQQHOWDSWRWKH6:
LWHPRIWKHFKDQQHO\RXZDQWWRFKDQJHFDOOWKHVZLWFK
VHWXSVFUHHQDQGVHOHFWWKHVZLWFK
"--" : Always ON.
"SA"~"SH": The switch which enables student
side operation can be selected. (See "Switch
selection method" at the end of this manual
for selection method details.)
Trainer student channel setting function
,QWUDLQLQJPRGHWKHLQVWUXFWRUVWUDQVPLWWHUFDQ
SLFNXSWKHVWXGHQWVVLJQDORQERWKWKH)XQFWLRQ
DQG0L[FKDQQHOV7KDWPDNHVLWHDV\IRUWKH
WZRWUDQVPLWWHUVWRFRQQHFWHYHQLIWKHVWXGHQWDQG
LQVWUXFWRUKDYHVHWXSWKHLUWUDQVPLWWHUVGLIIHUHQWO\
:KHQWKHLQVWUXFWRUVWUDQVPLWWHUPRGHLVVHWWR1250
WKHVLJQDORIWKHVDPHFKDQQHORIWKHVWXGHQWVWUDQVPLWWHULV
RXWSXWDVLV7KHVDPHDVEHIRUH