FUTABA T18SZ - Page 133

133
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
Elevator → Camber
[Corresponding model type]: Airplane/glider, 2 ailerons or more
This function is used when you want to mix the
FDPEHUÀDSVZLWKHOHYDWRURSHUDWLRQ:KHQXVHG
WKHÀDSVDUHORZHUHGE\XSHOHYDWRUDQGOLIWFDQ
be increased.
1RWH7DLOOHVVZLQJHOHYDWRUFDQEHRSHUDWHG
ZKHQWKLVPL[LVDFWLYDWHG
ŏ A mixing curve can be set.
ŏ Mixing during Áight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
ŏ The mixing rate can be Àne-tuned by setting a VR.
Setting method
ŏ Tap [INH].
(ON is displayed.)
ŏ When setting a switch, tap the [--] item of
the switch and tap the screen to call the
selection screen, and then select the switch
and set its ON direction. (Always ON at "--"
setting)
(For a description of the switch selection
method, see the description at the back of
this manual.)
ŏ When setting a VR, tap the Fine tuning
"--" item and tap the screen to call the
selection screen, and then select the VR. The
adjustment rate can be set.
The VR operation mode can also be
selected.
ŏ A mixing curve can also be set.
(For a description of the curve setting
method, see the description at the back of
this manual.)
ŏ Select [ElevatorńCamber] at the model
menu and call the setup screen shown
below.
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Aileronsandflapsrate
adjustment
Overalladjustmentby
RateAandRateB.
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
FinetuningVRsetting
Operationmode
Adjustmentrate
Activatethefunctionby
tappingthe[INH].
ŏReturn to Model menu
Thevalueinsidethe
parenthesesshowsthe
currentrudderposition.