FUTABA T18SZ - Page 132

132
＜ Modelmenu(Airplane/Glider/MulticopterFunctions) ＞
RUDDER2
RUDDER
RUDDER
V-TAIL
RUDDER2
Winglet
RUDDER1
Winglet
atFlyingwing
atFlyingwing
()
()
AIL3
AIL3
(ChipAileron)
(ChipAileron)
AIL1
(MainAileron)
AIL2
(MainAileron)
Aileron →Rudder
[Corresponding model type]:
Airplane/glider, general
Use this mix when you want to mix the rudders
with aileron operation.
ŏ A mixing curve can be set.
ŏ Mixing during Áight can be turned ON/OFF by
setting a switch. (Always ON at [--] setting)
ŏ The mixing rate can be Àne-tuned by setting a VR.
Setting method
ŏ Tap [INH].
(ON is displayed.)
ŏ When setting a switch, tap to the [--] item
of the switch and tap the screen to call the
selection screen, and then select the switch
and set its ON direction. (Always ON at "--"
setting)
(For a description of the switch selection
method, see the description at the back of
this manual.
ŏ When setting a VR, tap to the Fine Tuning
"--" item and tap the screen to call the
selection screen, and then select the VR. The
adjustment rate can be set. The VR operation
mode can also be selected.
ŏ A mixing curve can be set.
[Fine tuning VR operation mode]
[LIN.] Mix i n g r a t e 0  at center of VR.
When the VR is turned clockwise and
counterclockwise, the mixing rate
increases and decreases, respectively.
[ATL+] Mixing rate 0 at left end of VR.
When the VR is turned, the mixing rate
increases.
[ATL-] Mixing rate 0 at right end of VR.
When the VR is turned, the mixing rate
increases.
[SYM.] When the VR is turned to the left or
right of the neutral position, the mixing
rate increases.
ŏ Select [Aileronń Rudder] at the
model menu and call the setup
screen shown below.
(For a description of the curve setting
method, see the description at the back of
this manual.)
Currentlyselectedconditionname
● Mixingcurvesetting
(Foradescriptionofthe
settingmethod,seethe
descriptionattheback
ofthismanual.)
Left/rightoverall
adjustmentatRateA
andRateB
Activatethefunctionby
tappingthe[INH].
Conditiongroup/single
modeselection(Gr./Sngl)
TheON/OFFswitchof
mixingischosen.
FinetuningVRsetting
Operationmode
Adjustmentrate
ŏReturn to Model menu