20
< BeforeUse >
ťƄƗƗƈƕƜŃƕƈƐƒƙƄƏ
Note: If you remove the battery while the
power is on, the data you have set will not
be saved.
1. Open the battery cover.
2. Disconnect the battery connector.
3. Close the battery cover completely.
1.Plug the transmitter cord of the special
charger into the charging jack on the side of
the transmitter.
2. Plug the charger into an AC outlet.
3. Check that the charging LED lights.
WARNING
Becarefulnottodropthebattery.
Neverdisconnectthebatteryconnector
fromtheT18SZtransmitterafter
turningoffthepoweruntilthescreenis
completelyblankandthetransmitterhas
shutdowncompletely.
*Internaldevicessuchasmemoriesmaybedamaged.
*Ifthereisanyproblem,themessage"BackupError"
willbeshownthenexttimewhenyouturnonthe
powerofthetransmitter.Donotusethetransmitter
asitis.SendittotheFutabaservicecenter.
WARNING
Neverplugthechargerintoanoutlet
otherthantheindicatedvoltage.
*Pluggingthechargerintothewrongoutletcould
resultinanexplosionorfire.
Donotplugandunplugthecharger
whenyourhandsarewet.
*Itmaycauseanelectricshock.
Donotovercharge/overdischargethe
battery.
*Overcharging/Overdischargingabatterycanresultin
burns,fire,injuries,orlossofsightduetooverheat-
ing,breakage,orelectrolyteleakage.
CAUTION
Whenthechargerisnotinuse,
disconnectitfromtheACoutlet.
*Dothistopreventaccidentsandtoavoidoverheat-
ing.
When the battery will not be used for a long time, to
prevent it from deteriorating we recommend that it be
kept in about the half capacity state instead of fully
charged. Also be careful that the battery does not en-
ter the over-discharged state due to self-discharge.
When the transmitter will not be used for a long time,
you should always remove its battery.
Periodically (about every 3 months) charge the battery.
The charging time when charging the FT2F2100BV2
battery with the optional special charger is approxi-
mately 3 hours.
ŵƈƇŃƖƒƏƌƇ
ŦƋƄƕƊƌƑƊ
ŦƋƄƕƊƈŃƆƒƐƓƏƈƗƌƒƑ
ŪƕƈƈƑŃƖƒƏƌƇ
ŵƈƇŃƅƏƌƑƎ
ƒƕ
4. Disconnect the charge plug.
5. Disconnect the AC plug.
Charger
AC
Totransmitter
chargingjack
ŦƋƄƕƊƌƑƊŃƄƑŃůƌũƈŃƅƄƗƗƈƕƜ