FUTABA T18SZ - Page 21

21
＜ BeforeUse ＞
ųƒƚƈƕŃŲũũųƒƚƈƕŃŲű
ThrottleStickLow
PowerSwitch PowerSwitch PowerSwitch
RightandLeftPush
RightorLeftLongPushRightorLeftLongPush
or
1.Turnonthetransmitterpowerswitch.
2.Turnonthereceiverorspeedcontrolpowerswitch.
Alwaysbesurethemotor/engineisstopped.
1.Turnoffthereceiverorspeedcontrolpowerswitch.
2.Thenturnoffthetransmitterpowerswitch.
ON
OFF
OFF
ON
ŷƘƕƑƌƑƊŃƒƑŃƗƋƈŃƓƒƚƈƕŃƖƚƌƗƆƋƈƖ
Ifthepowerswitchesareturnedoffintheoppositeorderthemodelmayunexpectedlyrunoutofcontroland
causeaverydangeroussituation.
ŷƘƕƑƌƑƊŃƒȭŃƗƋƈŃƓƒƚƈƕŃƖƚƌƗƆƋƈƖ
ūƒƚŃƗƒŃƗƘƕƑŃƗƕƄƑƖƐƌƗƗƈƕŃƓƒƚƈƕŃŲűŒŲũũŃ
When turning on the power, the T18SZ transmitter will begin emitting RF automatically after it
FRQ¿UPVWKHVXUURXQGLQJ5)FRQGLWLRQV7KHVWDWXVRIWKHWUDQVPLWWHULVGLVSOD\HGE\/('DWWKHXSSHU
part of the front of a T18SZ.
*If THR stick is high, a WARNING screen will appear. Another warning will appear if a power
supply is attached. (In Multicopter mode, the THR position alarm will not appear.)
ŬƉŃƗƋƈŃŅŷƋƕŃƓƒƖƌƗƌƒƑŅŃƄƏƄƕƐŃƇƌƖƓƏƄƜƖ
*If the throttle stick is in the high position when the
power is turned ON
Warningalarm
Tapthistostopthealarm
andRFsignal.Onlypanel
screenoperationisactive,the
transmitterwillnotlinktoany
receiver.
When the alarm activates, lower the throttle stick
before turning the receiver power ON.
*If the power is turned ON when the idle-up, air brake,
etc., switches are ON, the above warning will display.
Ensure the relevant switches are turned OFF.