GAT Access 6100 Terminal Series
Commissioning & Configuration
44
HB_GAT-ACCESS6100--EN_14
www.gantner.com
Figure 5.2 - Terminal settings display during start-up
The system settings can be changed via the service menu (see "5.3.1. Service Menu of the GAT Access 6100"). If
the service menu is not opened (i.e., if no action is performed at the terminal), the GAT Access 6100 continues to
start and then goes into idle mode. The main screen is displayed and the reading center LED flashes blue.
Figure 5.3 - Main screen (example)
To Next Page
Loading...
