GAT Access 6100 Terminal Series
Commissioning & Configuration
www.gantner.com
HB_GAT-ACCESS6100--EN_14
45
5.3 System Settings
The system settings of the GAT Access 6100 can be set directly on site via the service menu of the terminal. Most of
these settings can also be defined via the network using GAT Config Manager software.
5.3.1 Service Menu of the GAT Access 6100
The service menu can be accessed while the terminal settings (see Figure 5.2) are shown on the display during
initialization of the GAT Access 6100. While this display is shown, the function keys on the front of the GAT Access
6100 must be pressed in the following sequence: 1 - 1 - 4 - 4 - 2 - 3.
Figure 5.4 - Keys for activating the service menu (1 - 1 - 4 - 4 - 2 – 3)
The service menu is shown:
Figure 5.5 - Service menu of the GAT Access 6100
Navigation in the service menu is done by pressing the corresponding keys on the front of the housing. Generally,
key 3 is the "ESC" key and key 4 is the "OK" key. Both keys can be used to return to the previous menu, however;
"ESC" will discard any changes made to the settings and "OK" will save the changes made.
To exit the service menu completely, press key 3 ("ESC") and confirm the next screen with "Yes".
To Next Page
Loading...
