Chapter 3: System operation
146 Vigilant VS1 and VS2 Technical Reference Manual
Zone event
ALRM ACT | 18:00:34 01/01/2007 Z:008
Zone 08
Where:
ALRM ACT = Alarm event
18:00:34 01/01/2007 = Time and date the event took place
Z:008 = Zone 08
Zone 08 = Label (could be the default label or a custom label)
Device event
ALRM ACT | 18:00:34 01/01/2007 L:1 D:128
Loop 1 Device 128
Where:
ALRM ACT = Alarm event
18:00:34 01/01/2007 = Time and date the event took place
L:1 = Loop 1
D:128 = Device 128
Loop 1 Device 128 = Label (could be the default label or a custom label)
Event ID numbers and descriptions
Table 40: Event ID numbers and descriptions
Event ID Event description Event ID Event description
000 Loop 1 initialization: Loop 1 is
starting up
052 Dialer deliver fail: The dialer failed to
deliver a message to the receiver or
CMS
001 Loop 1 fault: A short or open was
detected on loop 1 affecting the
communications between the panel
and the devices on the loop
053 Dialer normal test: A dialer test was
conducted when the panel was in a
normal state
002 Loop 1 map fault: A mapping fault
was detected on loop 1 while the
panel was mapping the devices
054 Dialer abnormal test: A dialer test
was conducted when the panel was
in an off normal state
003 Loop 1 card fault: The loop 1 card is
not present or it is not working
properly
055 Dialer configuration: The dialer is not
programmed or has unverified
changes
004 Loop 1 uncfgrd alarm: A device on
loop 1 that is not programmed went
into alarm
056 Net recvr comm fault:
Communications between the panel
and the network receiver failed
To Next Page
Loading...
