Chapter 3: System operation
158 Vigilant VS1 and VS2 Technical Reference Manual
Disabling and enabling zones
Zones are typically disabled while maintenance is performed to prevent event
messages originating from the zone from being displayed, printed, or reported off-
premises. Disabling a zone does not prevent activations in the zone. All devices in the
zone continue to function normally.
Note: Remember to re-enable the zone as soon as you have finished working with it.
Resetting the panel does not restore disabled zones. These must be manually
enabled and then restored.
When you disable a zone:
• The common Disable LED turns on
• On a zone/device system, the LCD displays disabled messages for the zone and all
of the devices in the zone
• On a zone only system, the LCD displays a disabled message for the zone
• The common trouble LED flashes and the panel goes into a trouble state
• The common trouble relay changes state
• The disabled and active points indicators on the LCD increment
• If you are using an LED display expander, the zone LEDs blink for the zone
• Resetting the panel has no effect on a disabled zone, but removing all power from
the panel enables the zone.
• If the zone you are disabling contains devices that are active, a warning message
is displayed.
To disable or enable a zone:
1. Press the menu button and choose Control.
2. Enter a level one password.
3. Choose Enable/Disable.
4. Choose Zone.
5. Select the zone that you want to disable or enable.
6. Press Enter.
7. If devices in the zone are active, acknowledge the
warning message by selecting Continue to disable
the zone or Cancel to exit.
The zone is disabled.
8. Press Cancel to return to the previous menu.
Main Menu
Reports
Test
Control
Program
⇩
Enter Password
0000
⇩
Control
Enable/Disable
Activate/Restore
⇩
Enable/Disable
Device
Zone
Panel Event
To Next Page
Loading...
