Chapter 2: Front panel programming
Vigilant VS1 and VS2 Technical Reference Manual 51
Setting up the programmable keys
There are two control panel buttons that can be assigned to correlation groups in
order to:
• Disable and reenable panel NACs, devices, and zones
• Activate panel NACs and devices
• Restore panel NACs and devices
• Unlatch all output devices globally
By default, the buttons are not programmed. The buttons can be labeled to indicate
their function with a slip-in label. To operate the buttons, you must be logged on with
a level one password or greater.
Figure 45: Programmable keys
Key 1
label
Key 1
Key 2
label
Key 2
00:00:00 01/01/07
,
Note: You cannot program a key while it is active. If the “Key is active” message is
displayed, wait until the key deactivates.
To Next Page
Loading...
