Chapter 2: Front panel programming
46 Vigilant VS1 and VS2 Technical Reference Manual
Setting the time and date
The first step in programming the panel is setting the time and date. You must do this
before using either the Auto Program or Advanced Program command.
To set the time and date:
1. Press the menu button and choose Program.
2. Choose Date and Time.
3. Enter a level one password.
4. Enter the current date.
5. Enter the current time.
6. Choose Save.
7. Press the Menu button to exit menu mode, or
continue programming.
Main Menu
Reports
Test
Control
Program
⇩
Program
Auto Program
Advanced Program
Date and Time
⇩
Enter Password
0000
⇩
Date and Time
Date 01/01/2007
Time 00:00
Daylight Savings
⇩
Date and Time
Time 00:00
Daylight Savings
Save
To Next Page
Loading...
