GE Security Vigilant VS1 User Manual

Chapter 2: Front panel programming
Vigilant VS1 and VS2 Technical Reference Manual 61
NET options
Table 19 describes the network options used to set up the Ethernet card.
Table 19: Auto programming — NET options
Option Description
Account ID
Enter the six-digit code for the central monitoring
station (CMS) account.
IP Enter the IP address for the CMS.
Event
notification
Set event notification (event reporting) to:
Device: Only device information is reported or
transmitted, no zone information.
Note: This setting uses default device event
notification settings for reporting events. See
“Factory default settings” on page 35.
Zone: When a device is a member of a zone, only the
zone information is reported or transmitted, no
device information. Note: This setting uses default
zone event notification settings for reporting events.
See “Factory default settings” on page 35.
Event: Only the event type (alarm, supervisory,
trouble, etc.) is reported or transmitted, no device or
zone information. Note: This setting uses the default
CMS event notification settings for reporting events.
See “Factory default settings” on page 35.
Network
Account ID 676968
IP 000.000.000.000
Event Notif. Event>
Network
Receiver# 000
Line# 000
Save
Receiver
number
Enter the CMS receiver number. Specifies the CMS
receiver number to be displayed in the message sent
to the receiver. This number is user-defined.
Line
number
Enter the CMS receiver line number. Specifies the
receiver’s line number to be displayed in the
message sent to the receiver. This number is user-
defined.

GE Security Vigilant VS1 Specifications

General

Brand	GE Security
Model	Vigilant VS1
Category	Control Panel
Language	English