Chapter 2: Front panel programming
Vigilant VS1 and VS2 Technical Reference Manual 63
Labeling devices
If you set the Label Devices auto programming option to Yes, follow these steps to
label the devices.
To label devices:
1. Next to “Device,” enter the device number to be
labeled.
2. Enter a text label for the device (two lines of 20
characters). The default label is “Loop X Device XXX.”
3. Press Enter to save the label and go to the next
number of the device.
Note: Pressing the Enter button saves the current
label and then goes to the next available device so
that you can quickly go to each device and label it.
4. Enter a text label for the device (two lines of 20
characters).
5. Repeat steps 3 and 4 until all devices are labeled.
6. When you have finished labeling, place the cursor is
in the device number field, and press the Cancel
button to reopen the previous menu. Continue with
the next auto programming option.
Loop 1 Device 001
Label goes here
Label continued
<Save <Back
See “Programming relay and sounder detector bases” on page 95.
Labeling zones
If you set the Label Zones auto programming option to Yes, follow these steps to label
zones.
To label zones:
1. Next to “Zone,” enter the number of the zone to be
labeled.
2. Enter a text label for the zone (two lines of 20
characters). The default label is “Zone XX.”
3. Press Enter to save the label and go to the next
number of the zone.
Note: Pressing the Enter button saves the current
label and then goes to the next zone number so that
you can quickly go to each zone and label it.
Zone 01>
Label goes here
Label continued
<Save <Back
To Next Page
Loading...
