Vigilant VS1 and VS2 Technical Reference Manual v
Important information
Limitation of liability
This product has been designed to meet the requirements of NFPA 72 National Fire
Alarm Code, UL 864 Standard for Control Units for Fire Protective Signaling Systems,
and ULC S527 Standard for Control Units for Fire Alarm Systems. Installation in
accordance with this manual, applicable codes, and the instructions of the authority
having jurisdiction is mandatory. GE Security shall not under any circumstances be
liable for any incidental or consequential damages arising from loss of property or
other damages or losses owing to the failure of GE Security products beyond the cost
of repair or replacement of any defective products. GE Security reserves the right to
make product improvements and change product specifications at any time.
While every precaution has been taken during the preparation of this manual to
ensure the accuracy of its contents, GE Security assumes no responsibility for errors
or omissions.
FCC compliance statement
This equipment can generate and radiate radio frequency energy. If the equipment is
not installed in accordance with this manual, it may cause interference to radio
communications. This equipment has been tested and found to comply with the limits
for Class A computing devices pursuant to Subpart B of Part 15 of the FCC Rules.
These rules are designed to provide reasonable protection against such interference
when this equipment is operated in a commercial environment. Operation of this
equipment is likely to cause interference, in which case the user, at his own expense,
will be required to take whatever measures may be required to correct the
interference.
SA-DACT FCC information
Cautions
• To ensure proper operation, this dialer must be installed according to the
enclosed installation instructions. To verify that the dialer is operating properly
and can successfully report an alarm, it must be tested immediately after
installation, and periodically thereafter, according to the enclosed test
instructions.
• In order for the dialer to be able to seize the phone line to report an alarm or other
event when other customer equipment (telephone, answering system, computer
modem, etc.) connected to the same line is in use, the dialer must be connected to
To Next Page
Loading...
Need help?
General
