3.1 Configuring Communication Parameters 34
3.2 Creating a New Configuration File 35
3.3 Receiving an Equipment Configuration File 35
3.4 Opening a Pre-existing Configuration File 36
3.5 Saving a Configuration File 36
3.6 Sending a Configuration File for the Equipment 36
4 Tools 36
4.1 LOG 37
4.2 Administrative Tools 37
5 Configuration Tabs 38
5.1 General 38
5.2 Analog 38
5.3 Binary 40
5.4 Communication 41
5.5 Synchronization 48
5.6 Recording 51
5.7 Triggering 53
6 Monitoring and Web Interface 57
7 Alarm and Warning Reporting 58
Chapter 5: Records 61
1 Wave Form Records 61
1.1 Recorded Values 61
1.2 Recording Times by Trigger 61
1.3 Sampling Rate 62
1.4 Trigger Burst Limiter 62
2 Re-trigger and Record Concatenation 62
3 Disturbance and Continuous Disturbance Records 63
3.1 Recorded Values 63
3.2 Recording Times by Trigger 66
3.3 Sampling Rate 67
3.4 Trigger Burst Limiter 67
4 Trend Recorder 67
5 SOE - Sequence of Events Records 67
5.1 Sampling Rate 67
6 Record Format and Naming, and Mass Storage Capacity 67
6.1 Record Format 67
6.2 Record Naming 68
6.3 Mass Storage Capacity 69
7 Record Management and Access 69
7.1 Creating Installations 70
7.2 Creating Devices 70
Chapter 6: PMU 71
1 Synchrophasor Measurement and Broadcast 71
1.1 Reported Values 71
To Next Page
Loading...
