3 Recovering the DR60 IP Address
To verify recover the DR60 IP address or to validate the communication between the
device and the computer, the DR60 has a scanning tool in the DR60 Configurator tool,
which scans the network returning the IP Address of the found DR60. The scanning tool
in located in the Communication menu and is described in the Configuration Chapter.
4 Accessing the Equipment
The DR60 has basically two means of access. The windows tool named DR60
Configurator used to configure, download logs and firmware upgrade; and the Web
Interface for monitoring and remote trigger. Detailed information on how to proceed
the access using both ways is described in the Configuration Chapter.
The minimum requirements for the web interface is described in the next section and
the for the DR60 Configuration tool in the Installation Chapter.
4.1 Web Interface Minimum Requirements
Web interface requirement: Internet Explorer version 7 or higher, or Mozilla Firefox
version 3.0 or higher;
To Next Page
Loading...
