A <New>: creates a new configuration file.
B <Receive>: receives a configuration file from the DR60 configured in the
Communication menu.
C <Open>: this button opens a file containing a pre-existing configuration.
D <Communication>: this button opens communications parameters for connecting
settings.
E <HMI>: this button opens the window containing information about the device.
F <Administrative Tools>: this button opens the window containing the following
options:
▪ Firmware update;
▪ Key update;
▪ Access control – allows changing the password for each kind of user (CFG,
ADM and MON);
▪ Support file – Downloads a support file containing internal logs used for
diagnosis.
On the initial screen, it is also possible to change the software language by clicking the
icon on the bottom right corner.
3.1 Configuring Communication Parameters
The <Communication> button on the initial screen opens the Communication Setup
screen that allows the configuration of the parameters to connect with the DR60. The
DR60 Configurator can communicate with the DR60 using serial RS232/RS485 or
Ethernet interfaces. The serial ports parameters and the IP address of the to be
connectedDR60.
The following option are available on the screen:
• Serial:
▪ Ports
▪ Speed
▪ Data Bits
▪ Parity
▪ Stop Bits
• Ethernet
▪ IP Address
▪ Name: inserts the identification name of this connection.
▪ Saved Connections: shows the name of the saved connections.
▪ <Add>: this button adds a connection name to the Saved
Connections area.
▪ <Remove>: this button removes a selected connection name from
the Saved Connections area.
To Next Page
