Patient data management
7-3
Automatic saving of patient data
The monitor continuously and automatically collects and saves patient data such as trends.,
Saving is activated once the patient is admitted or the monitor receives vital data.
If the monitor is not connected to the network, patient data is saved to the monitor memory.
If the monitor is connected to the network patient data is automatically saved to the network.
The network saves data from up to 2 to 90 days. The amount depends on the network
configuration.
Discharging the patient
When you end monitoring, discharge the patient. The monitor erases screen layout, trend data
and alarm and parameter settings that were active during monitoring, and returns to the
starting mode and its settings.
1. Press the
Admit/Discharge key.
2. Select Discharge - Yes.
NOTE: Please wait the message “discharged“ appear in the screen, then turn off the
monitor if you need, and please wait about 30 seconds at least to power on.
To Next Page
Loading...
Need help?
General
