GE Healthcare B30 - Changing the user modes

Monitor setup
5-5
Changing the user modes
You can change the settings in each user mode to suit your specific needs. User modes are
predefined combinations of settings that include both general and measurement specific
settings. A user mode defines, for example, what is displayed on the screen and in the trends.
General settings can be changed in the Monitor Setup menu, other settings in the parameter
setup menus. You need a password to make changes through Monitor Setup - Install/Service
menus and to enter the Save Modes menu; for details, see ”Configuration and passwords”
page 5-1.
This section describes the following changes that can be saved in user modes:
“Changing the Normal Screen layout” on page 5-8
“Changing sweep speeds” on page 5-12
“Displaying pulse rate” on page 5-12
“Changing parameter colors” on page 5-12
“Changing the recorder and printer settings” on page 5-13
Saving changes in user modes
The modifications are valid only temporarily unless you accept them by saving them in the
modes:
1. Select
Monitor Setup - Install/Service. Enter the password.
2. Select Save Modes. Enter the password (see page 5-1).
3. Select the mode from the list and select Save.
Temporary modifications are valid until you discharge the patient or change a mode or
until more than 15 minutes has elapsed from the turn-off of the monitor.