GE Healthcare B30 - Canceling a Measurement; Starting a Manual Measurement; Starting and Stopping a Continuous Measurement (STAT)

Non-invasive blood pressure
16-7
Starting a manual measurement
To start the measurement, do one of the following:
• Press the Start/Cancel module or side panel key, or
press the
NIBP key on the Command Board and select Start Manual.
Canceling a measurement
To cancel any NIBP measurement, do one of the following:
Press the
Start/Cancel module or side panel key, or
press the
NIBP key on the Command Board and select Cancel.
Starting and stopping a continuous measurement (STAT)
The STAT mode initiates continuous measurement for five minutes. A new NIBP measurement
starts immediately after the previous one.
In STAT mode the early systolic value is measured and displayed until the final result is
available.
After five minutes the monitor automatically returns to the previously selected cycling interval
or to manual mode.
To start the measurement, do one of the following:
• Press the NIBP key on the Command Board and select Star t STAT
To discontinue the measurement:
• press the NIBP key on the Command and select Stop STAT.